Table of Contents
Advertisement
Exhaust Hose Installation
1.
Move air conditioner to desired
location. See "Location Requirements."
2.
Screw one end of flexible exhaust
hose into the window slider connector and
screw the other end of the exhaust hose into
the exhaust connector. Ensure proper fit on both
ends.
3.
After connectors assembled, insert
the exhaust connector into the air outlet at the
middle back of the appliance. Push-in and then
rotate the exhaust hose anti-clockwise to secure
it onto the appliance. Ensure that all connections
are tight and installed properly.
4.
Extend the exhaust hose and insert
window slider connector into window slider kit.
Push the connector to the shorter end of Window
Slider Kit and fix it by using the screw provided.
Place window slider kit in window opening and
slide window to close against the window slider.
Alternatively, hang exhaust hose through window
opening if window slider cannot practically be
used.
Important Note
•
Ensure that there are no obstructions
, kinks in flexible exhaust hose that impedes the
exhaust airflow as this will affect the performance
of the Portable Air Conditioner and may
damage the appliance.
•
Do not over-bend or twist the venting
hose. Adjust hose length to shorter for better
performance efficiency.
•
Avoid exhaust-pipe with sharp bend.
•
Make sure air in exhaust pipe can run
smoothly.
•
The exhaust hose can be extended
from its original length of 50cm up to 150cm,
but it is best to keep the length to the minimum
required. Also make sure that the hose does not
have any sharp bends or sags.
Service And
Maintenance
Before cleaning or servicing this
unit, be sure to disconnect the unit from
any electrical supply outlet.
1.
Wipe the case with a slightly damp
cloth, then wipe dry with a dry cloth towel.
2.
Never pour water onto or into the
air conditioner. It could damage internal
components and create a shock and fire hazard.
3.
Do not use gasoline, thinner or
other chemicals to clean the unit. As these
substances may cause damage to the finish and
deformation of plastic parts.
4.
Do not wash the unit directly under a
tap or using a hose.
5.
If the power cord is damaged, it
should be repaired by manufacturer or its
agency.
12
Hide quick links:
Advertisement
Table of Contents
