Installation Of Indoor Unit; Selection Of The Installation Location For The Indoor Unit - Gree Versati III GRS-CQ8.0Pd/NhH-M Owner's Manual

Air-to-water Heat Pump Split Versati
6.2.3 Space requirements for installation
Wall
＞250
Wall
6.2.4 Precautions on installation of outdoor unit
(1) When moving outdoor unit, it is necessary to adopt 2 pieces of long enough rope to hand the unit from
4 directions. Included angle between the rope when hanging and moving must be 40 ℃ below to prevent
center of the unit from moving.
(2) Adopt M12 bolts components to tighten feet and under frame when installing.
(3) Outdoor unit should be installed on concrete base that is 10cm height.
(4) Requirements on installation space dimension of unit's bodies are shown in following drawing.
(5) Outdoor unit must be lifted by using designated lifting hole. Take care to protect the unit during lift. To avoid
rusting, do not knock the metal parts.
(6) Note that when release and refix the screw of the clasper, your hand should support the panal.And
then,after connected power cable,please ensure using the elastic trip of accessory to tighten with the pipe.

7. Installation of Indoor Unit

7.1 Selection of the installation location for the indoor unit

(1) Avoid direct sunshine.
(2) Ensure the hanger rod, ceiling and building structure have sufficient strength to support the weight of air
conditioner unit.
(3) Drainage pipe is easy to connect out.
(4) Indoor and outdoor connection pipes are easy to go outdoors.
(5) Do not install at a place where inflammable or explosive goods exist or inflammable or explosive gas may
leak.
(6) Do not install at a place subject to corrosive gas, severe dust, salty fog, smoke or heavy moisture.
＞200
＞350
＞1000
Wall
＞300
＞200
Wall
18
SPLIT TYPE
＞1000