Pioneer SC-82 Service Manual page 60

1
[4] DIGITAL MAIN_L ASSY
Remove the Bonnet 65 by removing the 18
screws.
A
-----------------------------------------------------------------
[4-1] DIGITAL MAIN_L ASSY
(1) Release the 7P Housing (ADX7814) from the
PCB binder.
B
Front
Note on assembling
∗26: Twist the PCB binder around the 7P Housing
(ADX7814) so that it doesn't touch to the
DIGITAL MAIN_L ASSY, D-AUDIO BRIDGE
ASSY and the Bonnet 65.
(2) Release the cables from the two PCB binders.
Note on assembling
C
∗27: Twist the PCB binders around the cables
(direction of the blue arrow), so that they
don't touch to the Fuse and the capacitor.
(3) Remove the HDMI Cable (ADX7777) by
disconnect the connector, and then connect
the another normal HDMI Cable.
Note: Don't connect the HDMI Cable (ADX7777)
provided with the product to prevent
damage to the HDMI connector for the
DIGITAL MAIN_L ASSY. Instead, use the
D
another normal HDMI Cable to prevent a
load from being applied to the HDMI
connector.
Always connect the HDMI Cable because
the iPod iPhone LED blinks, which causes
a shutdown, if the power is turned on
without the cable connected.
(4) Cut the two Binders.
(5) Release the cable from the two PCB binders.
(6) Disconnect the three connectors.
E
(7) Remove the screw. (BBZ30P060FCC)
Notes on assembling
∗28: PCB binders tilt in the direction of the blue
arrow.
∗29: Bind the HDMI Cable (ADX7777) and 7P
Housing (ADX7814) as numerical order of
blue numbers.
∗30: This PCB binder press only 31P FFC
(ADD7786).
F
60
1
2
Front
∗26
1
∗26
Front
Front
2
3
USB RECT_S ASSY
Fuse
∗27
HDMI Cable
3
JA8003
CN603
DIGITAL MAIN_L ASSY
CN601
D-AUDIO
BRIDGE ASSY
∗26
1
7P Housing
∗29
6
1
31P FFC
2
∗30
HDMI Cable
SC-82
3
4
2
∗27
FRONT HDMI USB ASSY
∗27
6
JA9620
7
6
6
4
∗28
5
5
∗28
31P FFC
V-REG_S ASSY
4
3
7P Housing
5
4