Pioneer SC-82 Service Manual page 55

5
(7) Connect the another normal HDMI Cable
from the FRONT HDMI USB ASSY.
Note: Don't connect the HDMI Cable (ADX7777)
provided with the product to prevent
damage to the HDMI connector. Instead,
use the another normal HDMI Cable to
prevent a load from being applied to the
HDMI connector.
Always connect the HDMI Cable because
the iPod iPhone LED blinks, which causes
a shutdown, if the power is turned on
without the cable connected.
(8) Connect the 29P board to board extension
jig cable. (GGD1856)
(DIGITAL MAIN_L CN603 <-> CONNECT_S CN7952)
(9) Connect the 5P PH Housing ASSY extension
jig cable. (GGD1594)
(A-REG_S ASSY CN7502 <-> AUDIO PF05PG-S20)
(10) Attach the PRE BRIDGE_S ASSY.
(11) Connect the 20P board to board extension
jig cable. (GGD1868)
(PRE BRIDGE_S ASSY CN6954 <-> AUDIO CN3052)
(12) Connect the Rear Panel to the Chassis /65
Ground and GND point of the D AMP_SS
ASSY.
(Refer to the "Ground Points" for the GND
point of the D AMP_SS ASSY.)
5
6
8
Front
29P board to board extension
jig cable (GGD1856)
PF05PG-S20
9
5P PH Housing ASSY
extension jig cable (GGD1594)
IR BUFFER_S ASSY
Front
D AMP_SS ASSY
SC-82
6
7
CN603
DIGITAL MAIN_L ASSY
7
HDMI Cable
JA9620
CONNECT_S ASSY
AUDIO ASSY
20P board to board
extension jig cable (GGD1868)
A-REG_S ASSY
9
CN7502
PRE BRIDGE_S ASSY
CN6954
11
Chassis /65
7
8
A
8
B
CN7952
C
11
CN3052
D
10
Rear Panel E
12
F
55
8