Adding And Draining Water; Choosing The Detergent; Cleaning The Recovery Tank - RCm Drive T 702R Instruction And Maintenance Handbook

DRIVE
Adding and draining water (fi g.4)
Before each cleaning operation, open the cap 11 (fi g. 3) and fi ll the solution tank with the right amount of water
and detergent. The tank is in polyethylene and is resistant to acids, bases and most solvents.
After cleaning, drain the dirty water from the recovery tank using the hose 2, by turning the lever 3.
Clean the recovery tank thoroughly at least once a week, opening the lid 1 and then raising the suction fi lter 4.
Wear protective gloves for this operatio

Choosing the detergent

For good cleaning results the correct detergent must be used. If necessary, request advice from the supplier or a
competent person, remembering that an excessively aggressive detergent may shorten the machine's working
life. A reduced foam detergent, or an anti-foam additive, must be used to avoid damage to the suction motor. If
it is not possible to obtain these products, ordinary wine vinegar can be used, pouring 50 cc. into the recovery
tank before washing. After using these detergents, wash your hands and refer to the instructions provided on
the information sheet of the detergent itself.

Cleaning the recovery tank

Every eight hours is necessary to clean the recovery tank, proceed as below:
- unscrew knob 5 and open cap 6.
- clean the recovery tank using the sponge, water or a high-pressure water jet machine.
- close cap 6 as soon as fi nished.
Danger!
Do not use corrosive products to do not damage the tank and the own health. It is
necessary to use gloves and protection glasses.
37