Advertisement
Protocol
MAC Address
IPv4 Configuration/ IPv6 Configuration
Network Connection Mode
Installing your VSP E590 and VSP E790 storage system
Hitachi Virtual Storage System E590, E790 Installation Guide
Running the Initial Setup wizard
IP addressing method to be used for
configuring the storage system.
Read-only field that shows the MAC
address for controllers 1 and 2.
IPv4 Address: IPv4 address of the
■
production network to which the
storage system will be connected
(IPv4 only).
IPv6 Address: IPv6 address of the
■
production network to which the
storage system will be connected
(IPv6 only).
Subnet Mask: IP address mask that
■
identifies the range of IP addresses
in the subnet to which the storage
system will be connected.
Subnet Prefix Length: Subnet prefix
■
length of the network to which the
storage system will be connected
(IPv6 only).
Default Gateway: IP address of the
■
default gateway to which the storage
system will be connected. The
gateway is the IP address of the
router used to communicate outside
the local subnet.
DNS Server 1-3: If your
■
configuration uses DNS to resolve IP
addresses (for example, the IP
address for the NTP server used with
the storage system), enter up to
three DNS IP addresses.
Determines whether the storage
system negotiates the speed and
duplex mode automatically with the
attached device. The default setting
(Auto-Negotiation) connects the
storage system at the highest speed
and appropriate duplex setting
supported by itself and the connected
device.
15
Advertisement
