Advertisement
7. Click Finish, and then click OK, Apply, and Close.
Next steps
Run the Initial Setup wizard.
Running the Initial Setup wizard
The Initial Setup wizard allows you to configure system information, date and time
settings, and network settings.
The Initial Setup wizard settings are presented on three windows. Buttons at the
bottom of each window allow you to apply or skip the settings on that window. If you
skip settings, you can complete them later by running the Initial Setup wizard again. To
display details about the settings in the windows, click the question mark icon in the
bottom right.
Before you begin
Log in to Storage Advisor Embedded, and then open the maintenance utility by clicking
the gear icon at the top-right corner and selecting User Administration.
Procedure
1. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
Hitachi Virtual Storage System E590, E790 Installation Guide
Tip: Initial Setup Wizard is near the bottom of the navigation tree. If
you do not see this selection, scroll down the tree.
Installing your VSP E590 and VSP E790 storage system
Running the Initial Setup wizard
13
Advertisement
