Related Manuals for Antari CINEMA HAZE CH-1
Summary of Contents for Antari CINEMA HAZE CH-1
- Page 1 CH-1 CINEMA HAZE User Manual - ENGLISH © 2021 Antari Lighting and Effects Ltd © 2021 Antari Lighting and Effects Ltd. www.antari.com...
-
Page 2: Safety Information
Pay attention to all warning labels and instructions in this manual and printed on the machine. If you have questions about how to operate the machine safely, please contact your local Antari dealer for help. Keep this device dry. -
Page 3: Product Dimension
․ If the supply cord is damaged, it must be replaced by a special cord or assembly available from the ․ manufacturer or its service agent. Product Dimension 579 mm 164 mm © 2021 Antari Lighting and Effects Ltd. www.antari.com... -
Page 4: Product Overview
Step 3: Connect gas inlet to gas cylinder equip with pressure regulator. (Gas inlet 9/16 – 18 R.H.) Step 4: Set pressure regulator between 50 to 60 psi, then open gas cylinder © 2021 Antari Lighting and Effects Ltd. www.antari.com... -
Page 5: Operation
Step 5: Fill the fluid tank with Antari approved fluid. Step 6: Press “ HEATER” menu, then press “ START” to start heating. Machine will take approximately 8 mins to heat up. Always connect the machine to a protected circuit and ensure it is properly grounded to avoid risk of electrocution. - Page 6 HEATER MENU DMX Setup Address 1 – 512 Channel Mode 1 / 3 / 5 Channels Link Mode Wireless / Wired Wireless Unlink Information Software Version Wireless Signal Temperature Pressure Device Hour © 2021 Antari Lighting and Effects Ltd. www.antari.com...
- Page 7 Making the DMX Connection – Connect the machine to a DMX controller or to one of the machines in the DMX chain. The machine uses both 3-pin and 5-pin XLR connector for DMX connection, the connector is located on the rear of the machine. © 2021 Antari Lighting and Effects Ltd. www.antari.com...
- Page 8 1 – 100% 0 – 127 Heater 128 – 255 0 – 127 Operation Mode 128 – 192 Timer 1 193 – 255 Timer 2 0 – 127 Cleaning 128 – 255 © 2021 Antari Lighting and Effects Ltd. www.antari.com...
- Page 9 IDENTIFY_DEVICE Fluid Use Antari CHL oil-based fluid for the best effect on CH-1 CINEMAHAZE. The machine is tested and calibrated with this liquid to get the best output performance. Warranty will be void if any other type of liquid is used, improper use of liquid may lead to machine faluire and malfunction.
-
Page 10: Service And Maintenance
- Gas cylinder not open properly - Gas cylinder running empty - Pressure regulator not set to range between 50 – 60psi (3.4 – 4.1 bar) - Pressure sensor failure or damaged © 2021 Antari Lighting and Effects Ltd. www.antari.com... -
Page 11: Technical Specifications
It may be caused by one of following: - Heater element failure or damaged - Main control PCB failure or damaged Please contact Antari dealer for advice if problem persists. Technical Specifications - Input voltage AC 100 – 240V, 50 – 60Hz... - Page 12 C08CH1000 © 2021 Antari Lighting and Effects Ltd. www.antari.com...
Need help?
Do you have a question about the CINEMA HAZE CH-1 and is the answer not in the manual?
Questions and answers