Panasonic KX-TD816 Programming Manual page 229

Button Code
# (Group-CO)
CO (Ringer frequency)
* Available when this system is connected to a Voice Processing System which supports digital
proprietary telephone integration (e.g. KX-TVP200).
Default
KX-TD816:
All jacks – CO buttons 1 through 8 = Single-CO 01 through 08; Ring tone type 2
Other CO buttons = Not stored
KX-TD1232:
All jacks – CO buttons 1 through 24 = Single-CO 01 through 24; Ring tone type 2
Programming
1.
Enter 005.
Display: Flexible Key Asn
2.
Press NEXT.
Display: Jack NO?
3.
Enter a jack number.
To enter jack number 01, you can also press NEXT.
Display: PT—PGM Mode
4.
Press the CO button which is changed to another button.
The display shows the contents pre-assigned to the button.
Display example: CO-01
5.
Enter a button code (plus parameter, if required).
To change the parameter, press CLEAR and enter the new parameter.
6.
Press STORE.
7.
To programme another CO button of the same jack, repeat steps 4 through 6.
To programme another jack, press SELECT and repeat steps 3 through 6.
8.
Press END.
Cancelling
1.
Perform the same procedures as steps 1 through 4 above.
2.
Enter 2.
3.
Press STORE.
4.
Press END.
ISDN Programming
1 through 8 (Outside line group number)
1 through 8 (Ring tone type number)
3.1 Manager Programming
Parameter
229