Tie Wink Time Out Assignment - Panasonic KX-TD816 Programming Manual

4.4 TIE Line Programming
[436] T IE Wink Time Out Assignment
Description
The TIE outgoing method can be set to the wink mode in programme [ 433]TIE Outgoing
Assignment. This programme sets the time the system waits for the confirmation wink signal
after an outside line is seized according to your central office service. The system disconnects
the outside line when the time-out expires.
Selection
• TIE table number: 1 through 4,
• Time: 1 through 127 (
Default
All TIE tables – 16
Programming
1.
Enter 436.
Display: TIE Wink Timeout
2.
Press NEXT.
Display: Table NO?
3.
Enter a TIE table number.
To enter TIE table number 1, you can also press NEXT.
Display example: 1:16
4.
Enter the time.
To change the current entry, press CLEAR and enter the new number.
5.
Press STORE.
6.
To programme another TIE table, press NEXT or PREV, or SELECT and the desired TIE
table number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• You cannot leave the entry empty.
• To assign all TIE tables to one selection, press the
shows the contents programmed for TIE table number 1.
318
( =all TIE tables)
64 milliseconds is the actual time)
key in step 3. In this case, the display
E & M Programming