Installation Requirements - ZALMAN CNPS9700 NT User Manual

8. Installation Requirements

If the case is equipped with an Air Guide, then the Air Guide Duct must be removed before installation.
Refer to the following diagrams, and install only on systems that meet the following installation requirements :
① No interfering components (PSU, graphic card etc.) within 62mm from the center of the CPU.
No interfering components (ODD etc.) within 48mm from the center of the CPU.
Case cover must be at least 150mm apart from the motherboard.
System Fan
Air Flow
Case
9. Installation
※ ※ The Clip Installation Method
The CNPS9700 must be installed in the orientation that matches the rear system fan's airflow.
(Refer to the diagram above)
The Clip installation method depends on the motherboard's socket orientation.
Follow the correct installation method for your motherboard type.
Be careful not to exert excessive force on the fan during installation of the Clip, as it may damage the fan.
A. For motherboards with a horizontally-oriented Retention Guide
B. For motherboards with a vertically-oriented Retention Guide
Retention Guide
The specifications of any product may change without prior notice to improve performance.
※
PSU
48mm
Graphic Card Slot
Clip
Retention Guide
Case Cover
Motherboard
Clip
3