Oki IP-6620 Maintenance Manual page 195

MEDIA JAM ERROR
LIFT THE LEVER
<Description>
One of the following problems has occurred.
- The media edge is not detected.
- The sheet media is used, and its media length a standard size.
<Action>
Solve the problem following the instruction in the message displayed.
If the error persists, check the Items to be Checked on the table below, and perform the actions
starting from the top until the problem is solved.
No
Media surface condition
1
Non-reflecting tape condition on
the platen
2
Media edge sensor condition
3
PCB-ASSY-HCB1M
4
PCB-ASSY-ACT3
5
PCB-ASSY-IPB5-100
6
Robot cable
7
FFC
8
5-36
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
Items to be Checked
OKI Data Infotech Corporation CONFIDENTIAL
2
The media edge may not be detected when the condition is as
follows.
- Black-surface media; or
- Matte media.
Try another media.
Check that the tape is not smeared. If it is, softly wipe it with a
soft cloth or lint-free paper dampened with wiper cleaning
liquid or cap cleaning liquid.
Check that the harness connector is securely connected to
the board's connector.
Check that the sensor is fixed securely.
Remove the sensor, softly wipe it with a soft cloth or lint-free
paper dampened with ethanol, and re-connect it.
If the error persists, replace the sensor.
Replace the PCB-ASSY-HCB1M.
Replace the PCB-ASSY-ACT3.
Replace the PCB-ASSY-IPB5-100.
Replace the robot cable.
Replace all four FFCs.
Action