Table of Contents
Advertisement
Söllnerstr. 9
92637 Weiden
info@traeger.de
+49 (0)961 48 23 0 0
⇒ configure the interface parameters in the section "terminal"
(eg: baud rate „9600", Parity„even", Data bits „8", Stop bits „1").
6. Now you can start with your work. If you have finished work you can transfer this project to the panel by
reading the next steps.
7. Choose „Transfer Settings" from the sub menu „Transfer".
8. In the new dialog change the „Mode" to „serial" and set the „Station address" of the operator panel
(e.g. „1"). Please set the baud rate to "19200". The "Delta transfer" is not supported by the S5-LAN. Turn
them so "Off".
9. Press the button „Transfer" to start communication with the terminal. Your project is about to be
transferred. The communication with the operator terminal is so successfully established .
PG-USB user manual
13 / 23
2021/02/28 16:13
Advertisement
Table of Contents
