Golden Compass HD GP620 SS Owner's Manual page 15

SEAT REMOVAL/INSTALLATION
The standard (20 x 20) seat assembly weighs about 51 pounds.
Please ask for help if you do not feel capable of safely lifting that much weight.
Removal of arms will significantly reduce the weight of seat.
Be sure the seat is correctly installed and locked before operating
your power chair.
Never pull on the arms or use them as a handle to move the power
chair as they could inadvertently pull out of the receiver bar causing injury.
REMOVAL
1. Disconnect the controller cable from the joystick. "Unclip" from arm and remove
Velcro tie-wraps. See figure 2 on page 13.
2. Lift the front and rear seat lock handles and slide the seat until all (4) of the seat
guides are out of the receivers.
INSTALLATION
The seat can be installed from either side of the power chair.
1. To install the seat, align the seat guides (front and rear) with the seat receivers
(front and rear).
2. Slide the seat towards the center of the power chair until the seat locks securely
in place. The front and rear locks must engage.
3. Reconnect the controller cable to the joystick cable.
Rear Seat
Lock Handle
ASSEMBLY
Figure 3
Figure 5
Rear Seat
Lock Handle
Front Seat
Lock Handle
Seat Guides
Seat Height
&
Angle Adjustment
14
Figure 4
Seat Locking
Handle
Seat Receiver
Figure 6
Front Seat
Lock Handle