Table of Contents
Advertisement
10.2.1. Wireshark (Windows/Linux)
1. Download/install Wireshark on a PC (https://www.wireshark.org/)
2. Connect the PC directly to the Ethernet port on the Stack Switchgear
3. Start a Wireshark capture on the network interface connected to the Stack Switchgear
4. In the 'filter' field, enter in arp.isgratuitous and press enter
5. Either reboot the Stack Switchgear, or unplug/plug the Ethernet cable
6. The device should send a 'Gratuitous ARP' on the Ethernet network. In Wireshark the 'Info' field
looks like: Gratuitous ARP for <IP> (Request) where the <IP> is the address for the Stack
Switchgear
7. Once that is complete, update the PC network settings to match the Stack Switchgear and
connect the Operator Interface.
•
Refer to
Section 5.2
10.2.2. Netdiscover (Linux only)
1. Install netdiscover on a PC (on Debian based systems use: sudo apt install netdiscover)
2. Connect the PC directly to the Ethernet port on the Stack Switchgear
3. Run sudo netdiscover -i <interface> -p where <interface> is the network interface connected to the
Stack Switchgear
4. Either reboot the deStack Switchgearvice, or unplug/plug the Ethernet cable
5. The device address and MAC will show up in netdiscover once an ARP packet is sent
6. Once that is complete, update the PC network settings to match the Stack Switchgear and
connect the Operator Interface.
•
Refer to
Section 5.2
In
the
support@nuvationenergy.com
Document ID: NE-PM-003
for instructions.
for instructions.
event
the
IP
for assistance.
Nuvation Energy High-Voltage BMS - Product Manual
address
cannot
be
92
discovered,
contact
Rev 1.2, 2021-03-03
Curie Update 1
Advertisement
Table of Contents
