Changing A Water Filter Cartridge - Indesit MSZ 902 NDF/HA User Manual

Changing a water filter
cartridge*
EN
cartridge out through the base grille.
Note: Since there is water in the cartridge, some
spilling may occur.
*
depending on model
32
1. Locate the water filter
cartridge cap below the
freezer compartment
door. Rotate the cap
counterclockwise to a
vertical position and pull
the cap and filter
2. Remove the cartridge
cap by sliding it off the
end of the old cartridge.
DO NOT DISCARD THE
CAP.
3. Take the new
cartridge out of its
packaging and remove
the protective cover
from the o-rings.
4. Slide the cartridge
cap onto the new
cartridge as shown.
5. With cartridge cap in
the vertical position,
push the new filter
cartridge into the base
grille until it stops.
Rotate the cartridge cap
clockwise to a horizontal
position.
6. RUN WATER THROUGH THE DISPENSER UNTIL
THE WATER RUNS CLEAR (about 9-14 litres or 6-7
minutes). This will clean the system and clear air from
the lines.
Note: as air is cleared from the system, water may
spurt out of the dispenser.
Ordering replacement filters
To order more water filter cartridges, please contact
your after-sales service.