Vehicle Setup - Car-O-Liner Speed Instruction Manual

Car-O-Liner Group AB
4.2

Vehicle setup

maximum
load offset
26
1 Make sure that no fastening arms and chassis clamps are mounted
on the lifting platform. For removing them, refer to the
Instruction manual for the Speed Draw aligner.
2 Make sure that the lifting platform is lowered to its lowest
position. Regarding operation of the lift, refer to Section 4.3 and to
the Instruction manual of the power unit.
3 Make sure that the lifting pads are in the lowest position.
WARNING! It is not allowed to place more than one extension block
(Extension 60) on each lifting pad. Risk for vehicle tilting.
4 Fold the lifting arms along the platform by rotating them
horizontally. Make sure that they are placed alongside the lifting
platform.
5 Roll the vehicle over the Speed Lifting platform.
WARNING! The highest allowed vehicle weight is 2,500 kg (5,500 lbs).
Risk for platform tilting, which may cause personal injuries.
WARNING! When placing the vehicle on the lifting platform, make sure
that the vehicle is placed within the maximum load offset. Otherwise, the
vehicle might overturn and cause personal injuries.
WARNING! The edge of the front wheels (or heaviest axle) must never
exceed the edges of the lifting platform.
WARNING! When the lift is in use, the entire vehicle should be supported
by the lifting platform. Do not lift one end of the vehicle while the other end
is resting on the floor. Risk for injuries.
Speed Lifting platform
32750, EN - rev. 7, 2018-04