Anchoring To The Floor - Car-O-Liner Speed Instruction Manual

Speed Lifting platform
3.6

Anchoring to the floor

1 2
32750, EN - rev. 7, 2018-04
IMPORTANT! It is the responsibility of the owner to ensure that the
equipment has been installed as specified in the instructions provided. It is
also the owner's responsibility to ensure that the lift is inspected in
accordance with current and local regulations before it is used.
WARNING! The Speed Lifting platform is designed to be permanently
anchored to the floor. If the lift is used without being properly anchored to
the floor according to these instructions, there is an imminent risk that the
lift will tilt and cause injuries.
The lift should be anchored to a flat floor with the following properties:
- A minimum of K25 concrete floor quality.
- A minimum of slab thickness of 150 mm (6 in).
- The requirements of the floor or the flatness of the floor (under the
lifting platform) is 2 mm/m or better.
Procedure:
3
Expander bolts M16x125, Car-O-Liners Art No. 36819. 4 bolts are supplied
with the Speed Lifting platform system.
1 Drill holes in the floor using the base plate holes as a template.
Drill diameter 16 mm (5/8 in), hole depth 110-120 mm (4-5 in).
2 Clean the holes with vaccum cleaner and air hose. Unscrew the
nut so that only the un-threaded top of the bolt is above the nut.
Gently tap the expander bolts into the holes with a hammer.
3 Tighten the bolts with a torque wrench set to 100 Nm (885 lbf-in).
NOTE! If the above torque is not attained, the anchorage is not
satisfactory.
IMPORTANT! If there is any uncertainty about the quality of the floor,
contact a building engineer for an inspection.
IMPORTANT! It is the responsibility of the owner (user) of the equipment
to ensure that inspection, in accordance with current local regulations, is
carried out before the lift is put into use.
Car-O-Liner Group AB
23