Sony DCR-SR220 Handycam&reg Handbook page 103

Remote Commander
 DATA CODE button (64)
Displays the date and time or camera
setting data of the recorded images
when you press this during playback.
 PHOTO button (22, 25)
The on-screen image when you press
this button will be recorded as a still
image.
 SCAN/SLOW buttons (23, 31)
   (Previous/Next) buttons (24,
31)
 PLAY button (23, 31)
 STOP button (23, 31)
 DISPLAY button (14)
 Transmitter
 START/STOP button (22, 25)
 Power zoom buttons (27, 33)
 PAUSE button (23, 31)
 VISUAL INDEX button (23, 30)
Displays the [VISUAL INDEX] screen
when you press this during playback.
  /  /  /  / ENTER buttons
When you press any button on the
[VISUAL INDEX] screen or Playlist,
the orange frame appears on the LCD
screen. Select a desired button or an
item with  /  /  / , then press
ENTER to enter.

Notes
Remove the insulation sheet before using the

Remote Commander.
Insulation sheet
Point the Remote Commander towards the

remote sensor to operate your camcorder
(p. 100).
When no commands have been sent from the

Remote Commander in a certain period, the
orange frame disappears. When you press any
of  /  /  / , or ENTER again, the frame
appears at the position where it was displayed
last.
You cannot select some buttons on the LCD

screen using  /  /  / .
To change the battery of the Remote
Commander
 While pressing on the tab, inset your
fingernail into the slit to pull out the battery
case.
 Place a new battery with the + side facing up.
 Insert the battery case back into the Remote
Commander until it clicks.
Tab
103