ABB Comem DTI Instruction Manual page 2

TEMPERATURE MONITORING DEVICE COMEM DTI AND COMEM EDTI - INSTRUCTION MANUAL
2
6.
6.1
6.2 Selection of the number of active inputs
6.3 Control ventilation
6.4 Selection of the threshold of switch on and switch off
6.5 Selection of the alarm and trip threshold
6.6 Selection of address network identification for the
6.7
6.8 Selection data bit and stop bit
6.9 Selection of the linked channel with the analogue output
6.10 Configuration output signal
6.11 Configuration diagnostic probes
6.12 Exit from the programming phase
7.
7.1
7.2
7.3
8.
9.
10.
11.
12.
13.
14. Dimensions
15.
16.
Programming of the device
Selection of the HOLD function
ventilation
communication of the serial port (MODBUS-RTU protocol)
Selection of the baud rate
Modality of tripping and restore
Alarm
Trip
To silence alarm
Diagnostic
Visualization of the maximum measured temperature
Visualization of the channels with the higher temperature 22
Test of the light signaling
Exclusion of the input probes not used
Technical features
Movement, transport and storage
Appendix A: MODBUS address.
11
11
12
12
13
13
14
14
15
16
17
18
18
19
19
19
19
20
21
22
22
23
24
25
26