Product Care - Össur FORMFIT TRACKER Instructions For Use Manual

Putting the hinges back
To put the hinges back into the brace, do as follows:
1. Close the hinges.
2. Hold the brace by its rear (Figure 9).
3. Fully fold the brace forward, over the hole for the kneecap.
4. Push a hinge into one of the hinge holes and open it lightly at the
same time. The two ends of a hinge will go into the upper and lower
halves.

PRODUCT CARE

You can wash the brace without removing its components.
Wash on a delicate cycle at max 30 °C with a mild detergent. Leave to air
dry. Do not tumble dry.
NOTICE: Make sure to fasten the strap ends before washing. If you do
not fasten the strap ends, they can damage the brace materials.
PRODUCT MATERIAL LIST
Polyester, polyamide, elastane, polyurethane (PU), silicone, acrylonitrile
butadiene styrene thermoplastic (ABS), stainless steel.
The product is not made from raw materials known to contain natural
rubber latex.
DISPOSAL
All components of the product and packaging should be disposed of in
accordance with respective national environmental regulations. Users
should contact their local governmental office for information on how
these items can be disposed of in an environmentally sound manner.
7