The Riff2 Page - Kurzweil PC3 Musician's Manual Addendum

The RIFF2 Page

The second Riff page appears as shown below, and has the following parameters:
Parameter
Trigger
Release
CondRel
Local
Loop
BPM
Sync Zone
Sync Type
Release Sync Zone (RelSynZn)
Release Sync Type (RelSynTyp)
Duration
Velocity
Offset
Trigger
There are a few ways to trigger riffs in setup mode. On the Riff2 page you can use the Trigger
field to set a keyboard key to trigger the Riff. Also, any physical controller can be assigned to
controller destination 163 RiffOn.
To set the key range to trigger your riff, use the cursor buttons to select the left value in the
Trigger field (this will be the low end of the trigger key range.) Now you can select the key
number by scrolling the Alpha Wheel, or you can use intuitive entry by pressing and holding the
Enter button on the alphanumeric pad and pressing the desired key on your keyboard. You will
see this value change as you press a key.
Range of Values
(HiKey) C -1 to G9
(LoKey) C -1 to G9
(HiKey) C -1 to G9
(LoKey) C -1 to G9
Off, On
Off, On
Once, Forever
Sequence, Setup, External, 20 to 400
First Avail., Riff 1-16, Main Seq, Arp 1-16, FirstRiff.Av., First
Arp.Av
None, DownBeat, AnyBeat, DownBeatWait, AnyBeatWait,
Loop, Stop, StartWait, LoopWait, StopWait
First Avail., Riff 1-16, Main Seq, Arp 1-16, FirstRiff.Av., First
Arp.Av
None, DownBeat, AnyBeat, DownBeatWait, AnyBeatWait,
Loop, Stop, StartWait, LoopWait, StopWait
1 to 1000%
0 to 255%
-32768 to 32767
Setup Mode
Riffs
Default
C -1
G9
C -1
G9
Off
Off
Forever
Sequence
First Avail.
None
First Avail.
None
100%
100%
0
3-21