Table of Contents
Advertisement
1.All batteries should be inserted in the correct polarity.
2.Non-rechargeable battery cannot be recharged
3.Before charging, the rechargeable battery must be taken out from the
toys.
4.Take out and properly deal with the dead battery. To avoid injury, please
keep kids away from the battery.
5.The direct contact between the positive and negative terminals may result
in fire or explosion. Avoid direct connect between the terminals.
6.Do not mix old and new batteries.DO not mix alkaline, standard(carbon-
zinc),or rechargeable(nickel-cadmium) batteries.
7.Only an adult who has read and understood the safety warnings can
recharge the battery.
Use a screwdriver to remove the battery cover of the remote control, insert
two AAA 1.5V dry batteries in correct polarity. Close the battery cover and
fix it with the screw. (Battery replacement also according to the above
steps)
2. Matching the frequency of car and remote control
Forward Button
Reverse Button
Operation manual: For the first time to use(Or Replace the
battery)Need to frequency bind
Take out the remote control,install the battery
Long press on the frequency key 2-4 seconds,Low speed LED lights
will flash
Turn on the power of the car,Low speed LED lights will from flash to
long lighting,then frequency bind succeed
If the frequency bind failed(Low speed LED lights flash), remove the
battery and repeat steps 1-3
Remote control without operation after 10 seconds,indication light will
off into power saving mode
Button Description:
forward
right
S: Speed P:emergency brake,press it and the running
function willfaal,press again,it release
13
LED Light
backward
turn left
turn
3.Instructions of the recoverable fuse
5A、10A、
13A、15A
4.Charging instructions.
3
When battery power is low,please charge it immediately. The charging port is behind
the seat. (Note: toys can not be operated in the charging state. Toys should be charged
under adult supervision ) ..
When the current exceeds 5 (or 10, or13, or
15) amperes, the recoverable fuse will
automatically cut off the power supply for 5-
10seconds, then the current will be
resupplied. (optional)
2
1
4
5
14
Advertisement
Table of Contents
