Table of Contents
Related Manuals for Lean Cars BDM 0909
Summary of Contents for Lean Cars BDM 0909
- Page 1 INSTALLATIONANDOPERATING INSTRUCTIONS WARNING: Assembly by an adult . This toy is unsuitable for children under 3 years due to its maximum speed. Executive standard: En71 and En62115 ASTM F963-17 Photos are for reference ONLY.
-
Page 2: Installation Instruction
INSTALLATION INSTRUCTION The illustrations in this instruction are used for easier understanding of the operation method of the product and the product structure. Please note there may be differences between the pictures and the physical item. In order to improve the quality, we may change part of the structure and appearance of the product without an advance notice. - Page 3 96 months...
-
Page 4: Specification
Specification Parts List specification Name PICTURE PICTURE (Recoverable fuse: 5A/10A/13A/15A) Battery and fuse Double drive (24V5Ah/24V7Ah) Double drive motor 24V Motor Steering motor 24V A(Rear axle) B(Front wheel) Suitable age 96 months Maxweight 30KG Body size 1180 800MM D(Wheel cover) C(Rear wheel) Speed Hours of use... -
Page 5: Installation Steps
Step3: Installation Steps Use H to fix [2](Steering connection) and[1] (M5 nut) Preparation before on [3] (the iron part of the front axle). installation: Take out all components from the packing box and the interior of the car body. Turn the car body upside down on a clean desktop or level surface. - Page 6 Step6: [2][1] 1. Put [2] (M8*16 shim) on [3] (steering column). 2. Use G (M8 spanner) to fix [3] [3] [1] (M8 nut) on [3] (steering column). ( clockwise ) Step9: 1. Use G (M8 spanner) to loosen [1] (M8 nut) on A (rear axle), and take off [2] (M8*22 shim).
-
Page 7: Direction For Use
Step14: Find the positive polarity (the red port), then connect it to the positive polarity positive polarity red port on battery, as shown in Figure. [2] [1] Step11: 1. Install [4](the front wheels)into both sides of [5](the front axle). (Note: the installation direction) Step15: 2. -
Page 8: Charging Instructions
3.Instructions of the recoverable fuse 1.All batteries should be inserted in the correct polarity. 2.Non-rechargeable battery cannot be recharged 3.Before charging, the rechargeable battery must be taken out from the When the current exceeds 5 (or 10, or13, or toys. 15) amperes, the recoverable fuse will 5A、10A、... - Page 9 6.Remote control in change direction: Press Steer Left, the car will turn left; press steer right, the car will turn right. tail box unlock switch R (Turn to anti - tail box unlock switch R (Turn to anti - clockwise position to unlock the box; clockwise position to unlock the box;...
- Page 10 a simple circuit diagram for the collocation of 2.4G remote control and double drive Recoverable fuse electric source charge port 1. Low battery voltage 2. Electric protection Recharge the battery electric Receiving 3. Switch is not reaching the Stop using for a few minutes source correct position Use it according to...