Advertisement
REASSEMBLY
AIR VALVE PLUNGER
• Place Air Valve Seal [M] on notched end of
Air Valve and align the Air Valve Spring [P]
and Air Valve Spring Bushing [N] on end of
plunger (FIG 11).
• Thread Air Valve into gun body and tighten
with the 13mm notch of the paint gun
wrench. (included with Paint Gun).
PACKING
• Partially slide the end of the needle into
the bore to help with alignment then stack
the Needle Packing [J], Needle Packing
Spring [K] & Needle Packing Nut [L] over
it (FIG 12).
• Thread the Needle Packing Nut [L] into gun
body and tighten with the 6mm notch of the
paint gun wrench (included with Paint Gun).
DO NOT OVERTIGHTEN! Slide the Needle in
and out as the Packing Nut is tightened to
check packing compression. Only a slight
amount of drag should be felt when sliding
the needle. Excessive tightness will cause
binding of the needle during Paint Gun
operation.
FLUID CONTROL/NEEDLE
• Push Needle in fully until it seats.
• Snap the Needle Tension Spring Bushing
[H] into the Needle Spring [G] and with the
Bushing at the outward end, slide them over
the Needle (FIG 13).
• Set the Fluid Control Knob over the Needle,
Spring and Bushing then thread in the Knob.
6
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
FIG. 11
P
FIG. 12
Needle
J
K
FIG. 13
Needle
N
M
Air Valve
L
G
H
Advertisement
