Advertisement
NOZZLE
• Unthread Nozzle from gun body with the
10mm notch of the paint gun wrench
(included with Paint Gun).
• Pull Nozzle Seal [D] from threaded end of
the Nozzle (FIG 4).
• Remove tan plastic Airflow Isolation Ring
[C] from gun body (FIG 5).
TRIGGER
• Lay the gun body on its side and using a
small screwdriver (not included), remove
one Circlip [F] from pivot shaft (FIG 6).
• Pull pivot shaft out of gun body and trig-
ger. Set trigger and pivot shaft aside for
re-installation (FIG 7).
4
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
FIG. 4
FIG. 5
C
FIG. 6
FIG. 7
E
F
Nozzle
D
E
Advertisement
