Advertisement
FLUID CONTROL/NEEDLE
• Unthread and remove Fluid Control Knob
from rear of gun body and set aside for
re-installation.
• Carefully remove Needle with Needle
Tension Spring [G] & Needle Tension
Spring Bushing [H] by firmly gripping rear
of Needle and pulling out through rear of
gun body (FIG 8). Set Needle aside for
re-installation.
PACKING
• Unthread Needle Packing Nut [L] from gun
body with the 6mm notch of the paint gun
wrench (included with Paint Gun).
• Withdraw the Needle Packing [J], Needle
Packing Spring [K] & Needle Packing Nut
[L] (FIG 9).
AIR VALVE PLUNGER
• Unthread Air Valve from gun body with
the 13mm notch of the paint gun wrench.
(included with Paint Gun).
• Pull Air Valve Seal [M] from end of Air
Valve along with Air Valve Spring [P] & Air
Valve Spring Bushing [N] (FIG 10).
Inspect and clean Gun Body as required.
Eastwood #12846Z Aerosol Injected Paint
Gun Cleaner is excellent for this purpose.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 8
Needle
FIG. 9
J
FIG. 10
P
N
G
H
K
L
M
5
Advertisement
