Onboard Device - Biostar TForce 550 SE Bios Setup Manual

TForce 550 SE
Primary/Secondary/Master/Slave UDMA
Ultra DMA function can be implemented if it is supported by the IDE hard
drives in your system. As well, your operating environment requires a DMA
driver (Windows 95 or OSR2may need a third party IDE bus master driver). If
your hard drive and your system software both support Ultra DMA, select Auto
to enable BIOS support.
The Choices: Auto (default), Disabled.
IDE DMA Transfer Access
This item allows you to enable or disable the IDE DMA transfer access.
The Choices: Enabled (default), Disabled.
Serial-ATA Controller
The Choices: ALL Enabled (default), Disabled, SATA-1.
IDE Prefetch Mode
The "onboard" IDE drive interfaces supports IDE prefetch function for faster
drive access. If the interface on your drive does not support prefetching, or if
you install a primary and/or secondary add-in IDE interface, set this option to
"Disabled".
The Choices: Enabled (default), Disabled.

Onboard Device

Highlight the "Press Enter" label next to the "Onboard Device" label and press
the enter key will take you a submenu with the following options:
20