Capacity; Control - Omega IF-006 User Manual

7.5.3.11 Probe Enumerating
The interface is in the process of enumerating the attached probe.
7.5.3.12 Extended Valid
The Extended Valid bit is set if the Password Error, Authentication Error and Probe Attached status bits
are valid.
7.5.4

Capacity

The Capacity provides a calculated 'battery capacity' remaining value, expressed as a percentage. For
Alkaline based batteries this is a linear calculation over a range 1.9 V
7.5.5

Control

The Control register determines the processes required for probe enumeration, the configuration of the
radio subsystem and allows the radio subsystem to acknowledge a shutdown request.
7 6 5
Connection
Type
15 14 13
7.5.5.1 Shutdown
The MSP processor advises the radio subsystem when power is too low to continue operation thru the
Reset Pending status bit. After appropriate processing by the radio subsystem it should set the
Shutdown bit in the control register which will force the MSP processor to shut down the sensor
interface.
7.5.5.2 Force Enumeration
If set, the enumeration process will be re-applied to the probe.
7.5.5.3 Authentication Required
If set, Probe Authentication is applied when probes are enumerated.
7.5.5.4 Connection Type
The connection type field provides support for Sub GHz radio technology.
Control Register
4 3
12 11
Connection Options
< see below >
Connection Type
Wired
Omega Sub Ghz
Reserved
DC
2
Authentication Force
Required Enumeration
10
0 0 0
0 0 1
. . .
and 3.0 V .
DC
1 0
Shutdown
9 8
23 | P a g e