CHAPTER 3: HEADERS & JUMPERS SETUP
3.1
H
S
OW TO
The illustration shows how to set up jumpers. When the jumper cap is
placed on pins, the jumper is "close", if not, that means the jumper is
"open".
Pin opened
3.2
D
S
ETAIL
ETTINGS
JUSBV1/JUSBV2: Power Source Headers for USB ports
Pin 1-2 Close:
JUSBV1: +5V for USB ports at JUSB1 and JUSBLAN1.
JUSBV2: +5V for USB ports at front panel (JUSB2/JUSB3).
Pin 2-3 Close:
JUSBV1: USB ports at JUSB1 and JUSBLAN1 are powered by +5V
standby voltage.
JUSBV2: USB ports at front panel (JUSB2/JUSB3) are powered by +5V
standby voltage.
Note:
In order to support this function "Power-On system via USB device," "JUSBV1/ JUSBV2"
jumper cap should be placed on Pin 2-3 individually.
P4M800 Pro-M7
J
ETUP
UMPERS
Pin closed
12
Pin1-2 closed
3
1
JUSBV1
Pin 1-2 Close (Default)
3
1
3
1
JUSBV2
Pin 2-3 Close
1
3
1
3
1
3