Intended Use - Renkforce 752168 Operating Instructions Manual

2. Intended use

This compact 2-zone alarm system was specifically developed for small shops,
apartments and caravans.
This diverse 2 zone alarm system has two alarm zones (differential loops), an
integrated door bell and signalling device and a status LED where the operating
status can be comfortably read.
The two alarm zones differ in the alarm activation function. Alarm zone 1 trig-
gers the alarm immediately and without delay in case of alarm. Alarm zone 2
triggers the alarm with a delay after the end of the entry delay.
Both alarm zones require an end of line resistor (EOL; included in the delivery).
For more information on this, see chapter: "7.1 Alarm Zones 1 and 2"
The integrated door bell can be activated with a conventional N.O. (normally
open) button that is connected to the connection terminals 9 and 10.
The alarm system can be armed during absence (AWAY), armed during pre-
sence (HOME) or disarmed (OFF) with the "mode selection switch" on the front.
Furthermore, e.g. up to two 8 Ohm speakers (connection terminal 4 + 5), an opti-
cal or acoustic signalling device (connection terminal 6 + 7; = N.O. relay contact)
and an external key switch, as well as an external status LED can be connected.
The operating voltage is connected to the terminal clamps 7 and 8 and can be
12 to 16 V/DC.
The alarm system is only suitable for dry indoor use.
Any use other than the intended use described above is not permitted and may
harm the product and result in short circuits, fire, etc. The entire product must
not be modified or converted. Always observe the safety instructions included
in these operating instructions. Please read the operating instructions carefully
and keep them for later reference.
29