Advertisement

3M
Attest
290 Auto-reader
Operator's Manual
Read and understand all safety information before using this product.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Attest 290 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for 3M Attest 290

  • Page 1 ™ ™ Attest 290 Auto-reader Operator’s Manual Read and understand all safety information before using this product.
  • Page 3 Intended Use The 3M Attest 290 Auto-reader is designed to A positive fluorescence reading or a visual color incubate and automatically read the 3M Attest change indicates a steam sterilization process 1291 Rapid Readout Biological Indicators (RRBI) failure. and/or 3M...
  • Page 4 - Do not immerse the Attest 290 Auto- reader in any liquid. - Avoid contact with the hot surface - Use indoors only.
  • Page 5 Underwriters Laboratories Inc. (UL) generated. against harmful interference when the equipment is operated in a commercial environment. This The Attest 290 Auto-reader is listed as Laboratory equipment generates, and can radiate radio equipment and carries the UL and c-UL marks...
  • Page 6 Step 4. Open the cover and Step 5. CLOSE the cover on the PLACE the RRBI into an Attest 290 Auto-reader and wait incubation/reader well. for either the red or green indicator light to signal the result.
  • Page 7 RRBI test may be invalid. applicable compliance requirements, inventory levels, and the risk to the patient if the medical device is not sterile. 3M © 2003 78-8078-8977-5 Page 5 of 9 Attest 290 Auto-reader...
  • Page 8 RRBI in the unit. proper functioning of Attest 290 Auto-reader components. Interpretation of Results Each incubation/reader well has three corresponding The final negative processed RRBI reading for a indicator lights: a red (+), yellow (•) and green (-)
  • Page 9 Place the power cord through the power cord- "alarm off" and "time remaining" buttons at the retaining clip on the rear of the Attest 290 Auto- same time. A yellow period will appear on the lower reader near the plug in. This will help to ensure that...
  • Page 10 TROUBLESHOOTING GUIDE Trouble Shooting Guide In the event of an error code, unplug the Attest 290 Auto-reader and plug it back in to initiate the self- diagnostic test. If error code re-occurs, call for repair or replacement. The display panel will indicate malfunctions detected by a specific error code. Refer to the following:...
  • Page 11 3350 Granada Avenue North Oakdale, MN 55128 1-800-292-6298 Fax: 1-800-770-8016 Outside of the USA, contact your local 3M Subsidiary. If you have questions, call our Customer Service number: 1-800-292-6298. 3M © 2003 78-8078-8977-5 Page 9 of 9 Attest 290 Auto-reader...
  • Page 12 3M Center 40% pre-consumer Building 275-4E-01 3M Health Care 10% post-consumer St. Paul, MN 55144-1000 D-41460 Neuss, Germany Litho in U.S.A. with 3M film, 1-800-228-3957 proofing systems and offset plates. Attest is a registered trademark of 3M.  3M 2003 78-8078-8977-5 Rev.

Table of Contents

Save PDF