Stanley Fatmax SFMCPS620 Instructions Manual
Hide thumbs
Also See for Fatmax SFMCPS620:
- Instructions manual (192 pages) ,
- Instruction manual (65 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Stanley Fatmax SFMCPS620
Summary of Contents for Stanley Fatmax SFMCPS620
- Page 1 SFMCPS620 www.stanleytools.eu...
- Page 2 English (original instructions) Copyright 2019...
- Page 3 Fig. A Fig. B...
- Page 4 Fig. C Fig. D Fig. E Fig. F Fig. G Fig. H...
- Page 5 Fig. I Fig. J Fig. K Fig. L Fig. M Fig. N...
- Page 6 Fig. O Fig. P Fig. Q Fig. R...
-
Page 7: Technical Data
The vibration and/or noise emission level given in this and 2011/65/EU. For more information, please contact information sheet has been measured in accordance with a STANLEY FATMAX at the following address or refer to the back standardised test given in EN ISO 11680-1:2011 and may be of the manual. -
Page 8: General Power Tool Safety Warnings
English Definitions: Safety Guidelines parts. Damaged or entangled cords increase the risk of electric shock. The definitions below describe the level of severity for each e ) When operating a power tool outdoors, use an signal word. Please read the manual and pay attention to extension cord suitable for outdoor use. -
Page 9: Important Safety Instructions
English preventive safety measures reduce the risk of starting the 6) Service power tool accidentally. a ) Have your power tool serviced by a qualified repair d ) Store idle power tools out of the reach of children person using only identical replacement parts. This and do not allow persons unfamiliar with the power will ensure that the safety of the power tool is maintained. -
Page 10: Specific Safety Rules
English 14 . Check Damaged Parts – Before further use of the appliance, mouth, eyes, or lay on the skin may promote absorption of a guard or other part that is damaged should be carefully harmful chemicals. checked to determine that it will operate properly and perform WARNING: Use of this tool can generate and/ its intended function. -
Page 11: General Safety Rules
English • Keep children, animals and bystanders at least 15 m away WARNING: For safe operation read and understand from pole saw. Only pole saw user should be in work area. owner’s manual. Wear face shield (and/or safety glasses) and hard hat to protect against falling debris. Always have •... -
Page 12: Residual Risks
Drive Sprocket or Sprocket - The toothed part that drives Chargers the saw chain. STANLEY FATMAX chargers require no adjustment and are • Guide Bar - A solid railed structure that supports and guides designed to be as easy as possible to operate. -
Page 13: Important Safety Instructions For All Battery Chargers
CAUTION: Burn hazard. To reduce the risk of injury, • NEVER attempt to connect two chargers together. charge only STANLEY FATMAX rechargeable batteries. • The charger is designed to operate on standard Other types of batteries may burst causing personal injury 230V household electrical power. -
Page 14: Important Safety Instructions For All Battery Packs
When the charger detects a battery pack that is too hot or too • Charge the battery packs only in STANLEY FATMAX chargers. cold, it automatically starts a Hot/Cold Pack Delay, suspending charging until the battery pack has reached an appropriate •... -
Page 15: Storage Recommendations
UN Recommendations on the Transport of Dangerous Have defective cords replaced immediately. Goods Manual of Tests and Criteria. In most instances, shipping a STANLEY FATMAX battery pack Charge only between 4 ˚C and 40 ˚C. will be excepted from being classified as a fully regulated Class 9 Hazardous Material. -
Page 16: Markings On Tool
Fuel Gauge Battery Packs (Fig. B) WARNING: Never modify the power tool or any part of it. Some STANLEY FATMAX battery packs include a fuel gauge Damage or personal injury could result. which consists of three green LED lights that indicate the level of... - Page 17 English nOTE: The fuel gauge is only an indication of the charge left on 6. When the saw chain is new check the tension frequently the battery pack. It does not indicate tool functionality and is (after disconnecting battery) during the first 2 hours of use subject to variation based on product components, temperature as a new chain stretches slightly.
-
Page 18: Operation
English Refer to to Joining Saw Head Module to Handle Module for CAUTION: Always reduce the tension off the chain again directions on how to attach the middle assembly to the handle after finishing work. The chain contracts as it cools down. assembly and saw head assembly. -
Page 19: Maintenance
WARNING: Since accessories, other than those offered by speed. Stop pole saw by releasing trigger switch Make sure saw chain has stopped before setting pole STANLEY FATMAX, have not been tested with this product, use of such accessories with this tool could be hazardous. saw down. - Page 20 English Guarantee 1 Year Guarantee All STANLEY FATMAX power tool products include a 1 year guarantee as standard. In the unlikely event that your powertool becomes defective due to faulty materials or worksmanship within 1 year of purchase, STANLEY guarantees to replace or repair all defective parts free of charge, or –...
-
Page 21: Troubleshooting Guide
English TROUBLESHOOTING GUIDE BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns For assistance with your product, visit our website at www.sTAnlEY FATMAX.com for a list of service centers. PROBlEM POssiBlE CAUsE sOlUTiOn Unit will not start. Battery pack not installed properly. - Page 24 United Kingdom Stanley Fat Max Tel. 01753 511234 270 Bath Road Fax 01753 572112 Slough, Berkshire SL1 4DX www.stanleytools.co.uk N729851 10/19...
Need help?
Do you have a question about the Fatmax SFMCPS620 and is the answer not in the manual?
Questions and answers
Need to lubricate does it have oil tank or just oil chain
The Stanley SFMCPS620 uses oil for lubricating the chain and guide bar, but the provided information does not mention the presence of a dedicated oil tank. Therefore, it cannot be confirmed whether it has an oil tank or only requires manual oiling.
This answer is automatically generated