Table of Contents
Advertisement
7s - 4
ACCESSORY DRIVE
DRIVE BELTS (Continued)
1 - BELT
2 - P/S PULLEY
3 - TENSIONER PULLEY
4 - CRANKSHAFT PULLEY
5 - BELT
Fig. 3 Generator Belt Adjustment
1 - ADJUSTING BOLT
2 - LOCKING NUT
3 - PIVOT BOLT
2001 NEON
Fig. 2 Power Steering / A/C Belt
6 - P/S PULLEY
7 - TENSIONER PULLEY
8 - A/C PULLEY
9 - CRANKSHAFT PULLEY
(3) After belt is installed, inspect belt length indi-
cator marks (Fig. 4). The indicator mark should be
within the minimum belt length and maximum belt
length marks. On a new belt, the indicator mark
should align approximately with the nominal belt
length mark.
GENERATOR BELT
(1) Install belt and/or adjust belt tension by tight-
ening adjusting bolt. Adjust belt to specification
shown in DRIVE BELT TENSION CHART .
(2) Check belt tension using Special Tool 8371 –
Belt Tension Gauge Adapter, and the DRBIII using
the following procedures:
WARNING: DO NOT CHECK BELT TENSION WITH
ENGINE RUNNING.
(a) Connect 8371 to the DRBIII
instructions provided with tool.
(b) Place end of microphone probe approximately
2.54 cm (1 in.) from belt at one of the belt center
span locations shown in (Fig. 5).
(c) Pluck the belt a minimum of 3 times. (Use
your finger or other suitable tool)
(d) The frequency of the belt in hertz (Hz) will
display on DRBIII screen.
PL
following the
Hide quick links:
Advertisement
Table of Contents
