MyBinding GBC SignMaker 25 Installation & Operation Manual page 22

S M 25/44
IGN AKER
13. Unroll 2 ft. (61 cm) of film. Drape the film over the top idler bar for
poly-in film and under the bar for poly-out film, (Fig 16).
14. Apply the bottom film to the top film so that they adhere together.
Reinstall the feed table.
15. Slide the threading card between the feed tray and the film web
lying on the tray, and gently push the threading card into the nip area
of the main rollers (Fig 17).
16. Replace the safety shield then push "RUN". Watch the leading edge
of the threading card to ensure that it enters the nip area of the heat
rollers and is being pulled into the laminator. The card will guide the
web of both film rolls into the heat rollers. Push "STOP" once the
threading card has exited the rear of the laminator.
17. Check film alignment. See section entitled FILM ALIGNMENT
PROCEDURE for instructions if installed film needs alignment.
CAUTION: THE FOLLOWING PROCEDURE IS PERFORMED
WHILE THE LAMINATOR IS HOT. USE EXTREME CAUTION.
AVOID CONTACT WITH THE HEAT ROLLER.
Page 6-4
Operating Instructions
Fig. 16
Fig. 17
©2004 General Binding Corporation