Operation - MyBinding GBC SignMaker 25 Installation & Operation Manual

Operating Instructions
Fig. 10
©2004 General Binding Corporation
S
IGN
OPERATING INSTRUCTIONS
6.0 O
PERATION
1. Turn the laminator on (I) at the main power switch located at the back
of the machine (Fig 10).
2. CAUTION: Make sure the safety shield and feed tray are in their
proper positions.
3. The laminator will automatically default to the "COLD" setting which
is used for PSA (pressure sensitive adhesive) film. For thermal film
press "HOT", when pressed, automatically sets the temperature to
230 ºF (110 ºC).
4. Do not begin laminating until the "READY" LED illuminates. The
normal warm-up time is approximately 10 minutes.
5. Position the roller gap handle to correspond to the gauge of film
laminated.
6. Position the item(s) to be laminated on the Feed Table.
7. Press "RUN". The rollers will begin to turn. Wait for the heat line to
disappear, then push the item(s) into the nip point of the heat rollers.
Additional items can be laminated without stopping and starting the
laminator.
8. Should a jam occur (wrap-up), press "STOP". Refer to the section
CLEARING A FILM JAM for specific instructions.
9. Stop the laminator when all of the items have completely exited the
rear of the machine.
10. Allow the laminator to remain powered if it is anticipated that it will be
used within a short period of time.
M 25/44
AKER
Page 6-1