Table of Contents
Advertisement
IP insulation grade
Type of installation
Attention! **The values indicated refer to the maximum temperature of the
environment of use of the device. It is the customer's responsibility to verify that the
temperature remains within the admissible range indicated in this manual and, if
necessary, adopt any passive cooling solution together with an application-dependent
cooling system that can ensure that the heat sink temperature will not damage the
device itself and/or the connected mechanical parts.
3.2
Software Specifications
D14XXXYY.BBB software version, where:
-
XXX is 000 in standard version and assumes other values in customized versions
-
YY is the revision
-
BBB is the BIOS version
Software version is released on the SECO website
and available, even in later versions.
3.3
CE reference directives
SECO S.p.A. places the device on the market, equipping and providing it with:
-
CE marking as IT device
-
Declaration of Conformity
-
User manual
Please also note that the device has been designed according to the following Directives:
-
2014/30/EU Electromagnetic Compatibility Directive
-
2014/53/EU (RED) (Where applicable, depending on the versions)
-
2012/19/EU (WEEE)
-
2011/65/EU (RoHS)
the device also meets the requirements of the following standards:
-
IEC 62368-1 ed. 3.0
-
IEC 60601-1 ed. 3.1
-
IEC 60601-1-2 ed. 4
-
IEC 60601-1-6:2010 + A1:2013
Information subject to change. Please visit
IP20
Fastening with screws
https://www.seco.com
to find the latest version of this manual. Page.7 of 29
www.seco.com
SYS-D14-MED
and is always updated
Advertisement
Table of Contents
