Table of Contents
Advertisement
To install the device properly on metal sheet/part/wall, follow the procedure below:
Make sure the electric connection on the destination machine is off and the
1
electric power supply is disconnected from the device.
Proceed to fasten the device to the wall,
2
using: screws
o type: M4
flat washer
o internal diameter 8.4mm in
points (A), indicated in the figure.
Proceed with the electrical connection of the device.
3
Proceed to electrically connect the destination machine.
4
A
A
Information subject to change. Please visit
A
A
www.seco.com
Page.22 of 29
to find the latest version of this manual.
SYS-D14-MED
Advertisement
Table of Contents
