Table of Contents
Advertisement
10 Electromagnetic Compatibility
This device needs to be installed and put into service in accordance with the information
provided in the user manual.
WARNING: Portable RF communications equipment (including peripherals such as antenna cables and
external antennas) should be used no closer than 30 cm (12 inches) to any part of the device,
including cables specified by the manufacturer. Otherwise, degradation of the performance of
this device could result.
The device is intended for use in the electromagnetic environment specified in the following
tables. The user should ensure that it is used in such an environment.
CAUTION: The device complies with the limits for devices contained in the reference standards.
However, the device may cause radio interference or may disrupt the operation of nearby
equipment. It may be necessary to mitigate this effect by reorienting or relocating the devices.
The device is intended for use in the electromagnetic environment specified in the following tables.
The user should ensure that it is used in such an environment.
Emissions Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/flicker
emissions
IEC 61000-3-3
Information subject to change. Please visit
Electromagnetic emissions
Compliance
Group 1
Class B
Class D
Compliant
to find the latest version of this manual. Page.25 of 29
www.seco.com
Electromagnetic Environment Guidance
The device uses RF energy for its internal
and system interface functions. Its RF
emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
The device must emit electromagnetic
energy to perform its intended function.
Electronic equipment located nearby can
be affected.
The device is suitable for use in all
establishments including
domestic establishments and those directly
connected to the
public low-voltage power supply network
that supplies buildings used for domestic
purposes.
SYS-D14-MED
Advertisement
Table of Contents
