Installation - Storage - AMC CU400 Installation Handbook

FUNCTIONS DESCRIPTION:
1) The Supervision is a transmission that the device runs automatically after a setted period of time during
which no openings or closures occur in the various connected contacts. This will enable the receiver to re-
port any communication's problem with the device itself. The time normally setted for this function is appro-
ximately 3 hours that guarantee a minimum of 8 daily transmissions. If you want, you can increase the time
interval to 15 minutes, minimum 96 transmissions per day, switching the DIP1 to ON.
2) The LED will turns on every time the the device is transmitting. If desired is possible to turn it off definitely
turning the DIP2 to ON.
3) In case of devices installed close to the receiver can halve the radio power (DIP3 ON) to avoid energy
wasting (increase battery life). To better understand if you can activate this feature, once installed the device,
use the RADIO SIGNAL MONITOR of the receiver verifying the received signal. A signal's level higher than
the 50/60% always offers a good safety margin of range.
4) If a device is installed to control highly used openings (eg. shop doors), you can enable the POWER
SAFE mode that inhibits the radio transmissions for a period of 10 minutes when there were 5/6 in the pre-
vious 10 minutes. Inhibition always begins after the contact's closure.

INSTALLATION - STORAGE

To program the device into the receiver,insert the battery in the proper space,following the right
polarity, and then use the LEARN Button to send the Learning Signal to the receiver.
Note: For the complete procedureplease refer to the Receiver's Manual.
To let become active the DIP-SWITCH configuration press the LEARN Button and check if the LED
blinks fast.Once placed the device in the desired position please use the Receiver's Test Tools to
check the radio range, the perfect box closure, the battery level etc.
Please refer to the Receiver's Manual.
www.amcelettronica.com
7
CU400 IT-EN v1.2