Electrical Connections; Installation Instructions - CDVI V3S Installation Manual

INSTALLATION MANUEL
Electromagnetic locks surface mount series

4] ELECTRICAL CONNECTIONS

T e r m i n a l
Correspondence
block
+ 12 or 24V dc
- -0 V
N.C Normally closed
COM
COM
N.O Normally open
The NO/NC signal only switches when
the door is closed with the power to it on.
Important note:
Check the jumper position before
connecting the lock to the 24 V DC
input current. A wrong position
could damage the lock. This type
of damage is not covered by the
warranty.

5] INSTALLATION INSTRUCTIONS:

- Identify the type of door (inward
or outward opening) and choose
an optional accessory if necessary.
- Drill a hole in the door jamb
to route the cable to the lock.
- Fix the mounting plate fi rmly
to the door frame.
- Position the armature
and accessory, if any, on the door
and check that it is fi tted but not
jammed. The electromagnetic lock
may be fi tted vertically or
horizontally on the door frame.
- Align the armature opposite the lock.
- Check that the lock is set to the
right voltage and apply the current.
When the door is closed the
armature should attach strongly
to the lock.
cdvi.com
4
cdvigroup.com
300, 400 and 500Kg 300, 400 and 500Kg
lock + blue lighting lock, version with relay.
Ref. CDVI: Ref. CDVI:
V3S - V4S - V5S V3SR - V4SR - V5SR
Ref. CDVI UK: Ref. CDVI UK:
S300 - S400 - S500 S300M - S400M - S500M
Voltage selection jumpers
12V dc
Power supply
12/24V dc
Current input
220/230V ac
Inside "Exit"
request push button
Outside "access
conrol" unit
300, 400 and 500Kg
lock + Buzzer
Ref. CDVI and CDVI UK:
V3SRB - V4SRB - V5SRB
24V dc
Electromagnet
Examples:
1. Proximity reader
2. Digicode
®
3. MIFARE reader
®