Dell Latitude 9510 Service Manual page 35

Steps
1. Remove the three (M2.5x5) screws securing the LCD hinges in place.
2. Rotate and lift the hinges up to remove the hinges.
3. Remove the three (M1.5x2.5) screws securing the fingerprint bracket in place.
4. Remove the fingerprint reader bracket from the system.
5. Peel off the power button with the fingerprint reader assembly from the sponge on the palm rest, and remove the power
button with fingerprint reader assembly from the system.
Installing the power button with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the fingerprint reader and provide a visual representation of the installation
procedure.
Steps
1. Align and place the fingerprint reader assembly on the system and adhere the power button with the fingerprint reader
assembly on the sponge on the palmrest.
2. Align and place the fingerprint reader bracket in place, and install the three (M1.5x2.5) screws securing the fingerprint
bracket.
3. Rotate and align the hinges down in place.
4. Install the three (M2.5x5) screws securing the LCD hinges in place.
Next steps
1. Install the I/O board.
2. Install the system fan.
3. Install the Base cover.
4. Install the SIM card tray
5. Install the microSD card.
Removing and Installing Components 35