6.0 System Operation; Start-Up; Operation; Shutdown - AirSep Topaz Instruction Manual

®
AirSep Corporation

6.0 System Operation

When you complete installation as described in the previous section, the oxygen
generator is ready for easy start-up and operation.
6.1

Start-up

1)
2)
3)
6.2

Operation

The oxygen generator operates automatically after start-up. Monitor the
performance of the oxygen generator at regular intervals to make sure the
product oxygen remains within the specifications (Refer to Appendix A of
this instruction manual).
6.3

Shutdown

1)
2)
Topaz/Topaz+/Topaz Ultra Instruction Manual
Set the l/O power switch to l, and wait two minutes to allow the
product oxygen to attain the purity specified in the Appendix A of
this instruction manual.
Rotate the flowmeter knob counterclockwise to increase flow or
clockwise to decrease flow as required for your application. The
flowmeter must never indicate a setting higher than that specified in
Appendix A for the particular model.
The flowmeter must be set at the specified flow rate.
Appendix A for the specified flow rates. At the appropriate flowrate
setting, top of the ball of the flowmeter will be at the level mark.
Increasing the flow of the product oxygen above
the flow specified in Appendix A of this
instruction manual results in reduced purity of
the product oxygen, potential damage to the
molecular sieve and the warranty will be voided.
Begin oxygen use by your application.
To stop oxygen delivery, rotate the flowmeter knob clockwise until
the flowmeter registers zero.
Set the l/O power switch to O.
Refer to
6-1