Configuration Via Menu; Basics; Diagram - Igema DLT2 Installation And Operating Instructions Manual

6. Configuration via menu

6.1 Basics

The menu of the DLT2/DLT3 is divided into two main levels:
Main level 1 | Main level 2
The menu is brought up by pressing the
menu, the associated yellow LED flashes or lights up.
"▲" "▼"
With the or keys you can choose between the menu items of the respective level.
"OK"
By pressing the
"ESC"
By pressing the
current entry being saved (with OK confirmed entries are already saved and remain so).
Automatic menus exit after 2 minutes if no key operation is carried out (cf. "ESC").

6.2 Diagram

| --- 1. ---
| - 1.1. |- Temperature of the probe
| --- 2.---
| - 2.1. |- Password input
| --- |----- After valid password input ------------------
| - 2.2. |- Programming of the min. level
| - 2.3. |- Programming of the max. level
| - 2.4. |- Programming of the damping*
| - 2.5. |- Tendency display**
Nur DLT3:
| - 2.6. |- Activation Overfill protection:
| - 2.7. |- Return level (%)
| - 2.8. |- Overfill limit level (%) / LIMIT
* The damping is a sliding mean value from the most recent measurements. The
number can be selected from the range of 3 – 30 values. The factory setting is
5 values. The measurement frequency is approx. 1 measurement/s.
On putting into operation please check setting.
** The tendency display shows a numerical value (e.g.
smaller with rising fill level. It can be used for example to check whether the
probe is immersed in the water.
The password is: 123 (The password is only for protecting the device
from unwanted changes. It offers no protection from malicious changes.)
Caution
"OK"
key you will get to the next level down or confirm the input.
key you can get to the next level up or out of the menu without the
key. While the operator is in the configuration
0 0 1 Overfill protection activ
2 5. 1) ) which becomes
15