Download
Share
Print this page
American Standard 2647 Series Installation Instructions Manual
  1. Manuals
  2. Brands
  3. American Standard Manuals
  4. Bathtubs
  5. 2647 Series
  6. Installation instructions manual

American Standard 2647 Series Installation Instructions Manual

Curved apron tub high gloss acrylic surface
Hide thumbs Also See for 2647 Series:

Advertisement

Available languages

Available languages

Quick Links

Download this manual
INSTALLATION INSTRUCTIONS
CURVED APRON TUB
HIGH GLOSS ACRYLIC SURFACE
MODEL: 2647 SERIES
Visit www.americanstandard.com for coordinating products.
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
BEFORE YOU BEGIN....
Local building codes vary by location. Observe all local plumbing and building codes.
Your new bath is shipped to you after careful inspection. All you need to finish the installation are your selected fittings.
To ensure maximum performance and pleasure from this product, please follow the instructions and cautions.
GENERAL INSTALLATION INFORMATION ...
1. When installing the coordinting bath walls (3060BW Series for example), additional studs may be
required. Refer to those installation instructions prior to installing tub.
2. Bath walls are to be installed over stud walls.
3. Bath may only be installed in a recess type installation.
4. It is recommended that the tub be set in a small bed of mortar or grout to compensate for uneven floors.
Stringers will help level tub but will not provide adequate support.
5. Take extra care when driving nails or screw to avoid damaging the bath.
TOOLS & MATERIALS REQUIRED....
TOOLS:
• Level
• Square
• Tape Measure
• Pipe Wrench
• Slip Joint Pliers
NOTE: Take extra care in handling surfaces of the bath. Use only non-abrasive cloths to avoid scratching.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
© A S A m e r i c a , I n c . 2 0 1 3
• Screw Driver
• Standard Woodworking Tools
• Personal Safety Equipment
• Caulking Gun
MATERIALS:
• Nails
• Plumber's Putty
• Silicone Sealant
• 1 x 3 or 2 x 4 Stringers
• Drop Cloth
• Mortar Mix or Grout
754749-100 Rev. C

Advertisement

loading
Need help?

Need help?

Do you have a question about the 2647 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for American Standard 2647 Series

Summary of Contents for American Standard 2647 Series

  • Page 1 Visit www.americanstandard.com for coordinating products. Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
  • Page 2 ROUGH-IN INFORMATION: 2647 CURVED APRON TUB 60" (1524mm) 9-1/2" (241mm) 15" (381mm) 3-1/16" (78mm) 3-13/16" (97mm) 30" (762mm) 1-7/8" (48mm) 33-3/4" C/L of pipe (857mm) location from tub edge 3-1/2" (89mm) 3" 1" (76mm) (25mm) GENERAL SPECIFICATIONS FOR 2647 TUB 60 x 30 x 18 In.

  • Page 3: Drain Connection

    A.) THIS BATH MUST BE SUPPORTED ALONG IT'S ENTIRE BOTTOM. We recommend the use of mortar as bedding material (sand is not recommended). Apply enough bedding to support the complete bottom of the bath. After the bedding has been poured, and before it sets, position the bath within the recess until the rim is leveled against the leveling stringers (see "Typical Recess Installation") shown below.
  • Page 4 (30) days of purchase. In no event will American Standard be liable for the cost of repair or replacement of any installation materials including but not limited to tile, marble, etc. This limited warranty does not apply to Commercial Installations. The warranty for Commercial Installations is three (3) years.

  • Page 5: Instrucciones De Instalación

    Visitar www.americanstandard.com.mx de la coordinación de productos. Gracias por elegir American Standard; referente de calidad durante más de 100 años. Para asegurarse de que el producto esté instalado correctamente, por favor lea estas instrucciones cuidadosamente antes de comenzar. (Ciertas instalaciones pueden requerir ayuda profesional.) Asegúrese de que su instalación cumpla con los códigos locales.

  • Page 6: Información Para La Instalación

    INFORMACIÓN PARA LA INSTALACIÓN: 2647 ELANTAL CURVADO BAÑERAS 60" (1524mm) 9-1/2" (241mm) 15" (381mm) 3-1/16" (78mm) 3-13/16" (97mm) 30" (762mm) 3-3/8" (86mm) Esta dimensión 1,5 = L/C 33-3/4" de conduce (857mm) por tubería la ubicación de la orilla de tina 3-1/2"...
  • Page 7 ESTA BAÑERA DEBE QUEDAR COMPLETAMENTE APOYADA EN SU PARTE INFERIOR. Le recomendamos usar mortero como material de cimentación (no se recomienda la arena). Aplique suficiente cimentación para soportar completamente la parte inferior de la bañera. Después de vaciar el material de cimentación, y antes de que se endurezca, ubique la bañera dentro del empotrado hasta que el borde quede nivelado contra los travesaños de nivelación (consulte "Instalación de empotrado típica") como aparece a continuación.
  • Page 8 3. Aplicación comercial. 4. Opciones y accesorios. La garantía limitada de American Standard sobre estos productos es de un año sólo para las piezas y no cubre gastos de mano de obra. Esta garantía limitada por un año cubre accesorios fabricados por American Standard (por ejemplo, revestimientos, drenajes, barras de agarre, calentadores, juegos de molduras) contra defectos de material o mano de obra.

  • Page 9: Instructions D'installation

    Visitez www.americanstandard.ca pour coordonner les produits. Merci d’avoir choisi un produit American Standard, synonyme de qualité exceptionnelle depuis plus de 100 ans! De façon à vous assurer d’une installation sans problème de ce produit, veuillez lire attentivement les instructions avant de commencer.
  • Page 10 RENSEIGNEMENTS SUR LA MISE EN PLACE DES CANALISATIONS : BAIGNOIRE 2647 PROSCENIUM ARRONDI 60po (1524mm) 9-1/2po (241mm) 15po (381mm) 3-1/16po (78mm) 3-13/16po (97mm) 30po (762mm) 3-3/8po (86mm) d'emplacement 33-3/4po de tuyau du (857mm) bord de baquet 3-1/2po (89mm) (76mm) (25mm) SPÉCIFICATIONS GÉNÉRALES POUR LA BAIGNOIRE 2647 60 x 32 x 18 po DIMENSION INSTALLÉE...
  • Page 11 A.) LE FOND DE CETTE BAIGNOIRE DOIT ÊTRE ENTIÈREMENT SOUTENU. Nous recommandons d'utiliser du mortier comme matériel de mise en forme (le sable n'est pas recommandé). Étendez suffisamment de mortier pour soutenir le fond de la baignoire. Une fois que le matériel (mortier) est coulé, avant qu'il ne soit sec, positionnez la baignoire dans son enfoncement jusqu'à...
  • Page 12 Pour activer cette garantie limitée, l'acheteur doit inscrire sa baignoire en ligne à notre site Web à www.americanstandard-us.com/warranty dans les 30 jours suivants l'achat. En aucun cas, American Standard ne pourra être tenue responsable des frais de réparation ou de remplacement de matériel d’installation, y compris mais non limité à, le carrelage, le marbre, etc.