Page 2
Table of Contents Equipment AutoSense Page 3 Standalone Cellular Page 3 Connectivity System Page 4 Verification Page 4 Regulatory Approvals Page 5 Technical Support Page 6...
Page 3
2. Mount on wall at least 6 ft. up and in front of dock doors using one of these methods: a. Mounting screws b. Cable ties and cable tie mounts 3. Plug power supply into a non-switched power outlet 4. Take picture of AutoSense Standalone and send it to CargoSupport@Emerson.com...
Page 4
Cellular Connectivity 1. Angle antennas away from the wall 2. After power is applied, verify the LEDs to right of the ethernet port are lit correctly a. Left LED is a solid GREEN indicating system is operational b. Middle LED is solid GREEN indicating connection to cellular carrier...
Page 5
Regulatory Approvals PakSense, Inc. Model: PSASII-03; FCC ID WPEPSASII-03; IC: 8031A-PSASII03 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the AutoSense II Inbound Standalone and is the answer not in the manual?
Questions and answers