Observint ALIBI ALI-BC1720 Series Quick Installation Manual

ALI-BC1720 Series HD-TVI Bullet
Cameras Quick Installation Guide
For Products: ALI-BC1720E, ALI-BC1720G
The ALIBI ALI-BC1720 series indoor/outdoor bullet cameras include a high sensitivity sensor with advanced
circuit design technology. They feature high resolution, low image distortion and low noise features which
makes them suitable for both surveillance and image processing systems.
Features
HD-TVI technology transmits zero latency HD video resolution over coax cabling
•
1280 x 720 (720p @ 30 fps) HD video for sharp, detailed images
•
2.8 mm wide angle lens (ALI-BC1720G only) captures images over large areas
•
Built-in 24 LEDs enables the camera to see up to 65 ft in the dark
•
Smart IR technology reduces over-exposure of the IR LEDs at the center of the image
•
True day/night (ICR) captures sharp, clear images in low light and at night
•
-40°F ~ 140°F extreme temperature operating range
•
IP66 weather-rated metal (ALI-BC1720E) or ABS (ALI-BC1720G) housing
•
Adjustable
mounting
bracket
Camera body
IR LED Array
ALI-BC1720E camera
Mounting base
IR LED Array
ALI-BC1720G camera
ALI-BC1720 series camera drop cable connectors
www.observint.com
1
Mounting base
Mounting
Bracket
Adjustments
Camera body
Lens
HD-TVI Video
BNC Connector
Power Connector
What's in the box
Camera assembly
•
Mounting hardware
•
This instruction guide
•
Drill template
•
What you need
To install the camera, you will need:
12 Vdc power source. See Specifications for wattage requirement.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Phillips screwdriver
•
Video and power extension cable
•
HD-TVI video setup monitor (optional)
•
Installation
Before installation:
Make sure that the device is in good condition and all the assembly parts are included.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
•
provide the rated voltage and wattage for the camera. See the Specifications section.
During installation:
Camera Lens: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
•
array shield becomes soiled, clean it only with approved products. See the
Power supply: Camera drop cable: The camera drop cable includes two connectors:
•
Video BNC connector: For transmission of the video signal across a coax (75 Ω) extension cable
Lens —
to an HD-TVI compatible recorder.
Power connector: When applying power, observe the power polarity. See the picture to the
—
right for the connector polarity configuration.
Mounting the camera
An ALI-BC1720 series camera can be mounted on a wall or ceiling that has sufficient strength to support it.
The video/power drop cable from the camera can be routed either through mounting surface or through a
cable guide in the mounting base.
ALI-BC1720 series camera typical ceiling mounting
If mounting the camera on a wall, ensure that the cable guide in the mounting base is down.
NOTE
If mounting the camera on a ceiling, orient the mounting base so that the cable guide is pointing
away from any source of water, dust, and other contaminates.
1. Using the drill template provided, mark the location of the screws that anchor the mounting base
to the mounting surface. See the note above. If you are routing the drop cable through mounting
surface, also mark the position of the hole for the drop cable.
section.
Cleaning
ALI-BC1720_CQ
8/26/15