LG D005KD1N111 Installation Manual page 29

B
NOTE
y For battery cable connections, the cross-sectional area of lead wire between 2.5 mm
2
4 mm is recommended.
y Battery cable is not supplied on this product package. The system installer is responsible
for selecting proper components for the installation.
C
42 mm
D
12 mm
Pass the battery cable through the
cable gland, rubber seal and housing as
shown in the figure.
Strip the battery cable as shown in the
figure.
1. Strip 42 mm off the battery cable.
2. Strip 12 mm off the every wires.
Connect the wires to the corresponding
wire hole on the contact carriers.
Wire hole L ↔ Battery wire +
Wire hole N ↔ Battery wire -
And then fasten the screws on the
contact carriers. (1 N.m)
Installation
29
2
2
and