Scale House NCS3K User Manual page 19

6.6 DISPLAY BACKLIGHT
By keeping pressed the ZERO-B.L. key, the display will scroll the possible activation modes; release the key when the
desired functioning is displayed:
OFF backlighting always off
ON backlighting always on.
AUTO backlighting on when the weight is unstable or when a key is pressed. The backlighting remains active for 5
seconds.
7. MESSAGES
MESSAGES
- - OF - -
Err 2 / ZERO
UNSTA
- - ADC - -
- SYS -
- LO -
- - AC - -
DESCRIPTION RESOLUTION
Over range Remove weight from the scale.
Zero Error Upon start-up or when the ZERO key is pressed, the weight on the
scale exceeds the +/- 10% of the max. capacity.
Remove the excess weight and retry.
Auto Zero Error Upon start-up, the weight on the scale is not stable to be zeroed. It
maybe because of the platform's intensity is too low or the platform is
shaken strongly.
You may strengthen the platform or avoid the shake.
Input signal Indicates that the A/D converter value is overflows:
overflow error - Remove the weight from the scale if it's exceeding.
- The load cell or the electronics could be damaged.
Calibration error Please re-calibrate the scale with the procedure with zero acquisition
(see section 6.3). If the problem persists contact the dealer.
Accumulator One can use the scale in a short time, but you should plug in the AC
voltage low plug as soon as possible to recharge the accumulator.
Accumulator
recharge.
19