Specifications - Caliber MCC 100 User Manual

seconds each time. During the memory station performing, press 1-6 digital buttons
to select and stop scanning function.
9.RESET BUTTON
Press it to rehabilitate the state when the program are distorted.
10,11. SOUND MODE AND ADJUSTMENT BUTTONS
Press SEL button repeatedly to select the one mode of BASS,TRE, BAL, FADER and VOL
(defaulted), and then press + or - button to adjust level of selected mode.
12.LCD (LIQUID CRYSTAL DISPLAY)
13.MODE
Press it to change into TAPE PLAY mode from RADIO mode.
14.TA function [TRAFFIC ANNOUNCEMENT] BUTTON
When pressed short, it is activated as TA mode on or off.
When TA mode is on and traffic announcement is transmitted:
1).When the unit is in TAPE mode, it will switch to radio mode temporarily.
2).Temporary switch over to an EON linked station when EON detects a traffic announcement
on the other program.
3).If the volume level was under the threshold point, it will be raised to the threshold point. If
the volume level was set to more than the threshold point (min.TA volume level), it will be set
to the last level.
When pressed long,TA SEEK mode on or off, and TPST ON/OFF will be displayed on LCD.
When the newly tuned station does not receive TP information for 5 seconds, the radio retunes
to the next station which has not got the same station(PI) as the last station, but does have the
TP information.
In TA seek mode, the current station can be changed to a completely different station because
the unit searches TP station when the field strength of the current station is very weak, or when
the current station has no TP signal.
15.TUNE UP OR DOWN BUTTONS
In RADIO mode, press ^ or v button shortly and repeatedly to manually tune up or down for
the desired radio station. Press ^ or v button for more than 2 seconds to automatically tune up or
down for the radio station of a strong signal.
16.EJECT KEY
At TAPE mode, push this key to stop tape playing and eject the tape from the cassette compartment.
17.CASSETTE COMPARTMENT
18. PANEL SIGNAL LAMP
This lamp flashes when the frontpanel of the unit is removed
GB 3
USER MANUAL
USER MANUAL

SPECIFICATIONS

Power Supply Main Unit DC 13.8 Volts. Negative Ground
Current consumption 10A MAX
Maximum Output Power 35W X 4
Unit Dimensions 178(W) x 160(D) x 50(H)
FM SECTION
Frequency Range 87.5MHz - 108MHz
AM SECTION
Frequency Range 522KHz - 1620KHz
ISO WIRING CONNECTION
B
W
C
D
E V
H
F
K
M
I
G
K J
H. FRONT GREY
B. ANTENNA PLUG
I. GREEN
C. MEMORY B+ PINK
J. GREEN/WHITE
D. BLACK( GND)
E. RED( B+) K. LEFT SP
F. FRONT L. RIGHT SP
G. REAR M. GREY/WHITE
T
S
U
R
N
F
L
Q
O
G
L
P
N. BROWN T. RED R
O. BLUE U. WHITE L
P. BLUE/WHITE V. FUSE 10A
Q. BROWN/WHITE W.FUSE 1A
R. YELLOW AUTO ANT
S. RCA LINE OUT
GB 4